Glow Saunas Electrical Information Guide
Important: This document is provided for general reference only. Glow Saunas does not take responsibility for electrical work, installation, or outcomes related to the information below. All electrical work must be carried out by a licensed electrician according to AS/NZS 3000 Wiring Rules.
Overview
This guide outlines the key electrical specifications required during the installation of your Glow Sauna. Please ensure this information is passed directly to your licensed electrician before any work begins. All wiring must meet the Australian and New Zealand electrical standards.
Power Requirements
- Power Supply: Single Phase, 230–240 V AC
- Circuit Breaker: 32 Amp RCBO
(combined RCD and circuit breaker)
- Cable: 6 mm², 2 Core + Earth (TPS)
These components ensure safe and stable operation of the sauna on a dedicated line.
Switch and Weatherproof Box
Your electrician should install:
- Isolator Switch: 40 Amp, Weatherproof, IP66 rated, 2 pole
- Weatherproof Adaptable Box: Approx. 380 mm width, 300 mm height, 120 mm depth
- Internal Connector: K16 plug connector fitted inside the box
This setup supports safe isolation and protection of the sauna’s electrical connection.
Additional Requirements
To maintain compliance and safety, your electrician must:
Use waterproof glands and UV rated conduit
Label the isolator switch:
“SAUNA ISOLATOR: DO NOT SWITCH OFF UNDER LOAD”
Ensure all wiring meets AS/NZS 3000 Wiring Rules
Quick Installation Notes
The sauna must run on a dedicated 32 A circuit
Check cable length and potential voltage drop
Mount the isolator in a location that is accessible and easy to reach
After installation, test:
- RCD
- Earth continuity
- Polarity
Your electrician will understand how to complete these checks as part of standard compliance testing.
Disclaimer
This document is for informational purposes only. Glow Saunas, its staff, and representatives take no responsibility for electrical installation, wiring outcomes, or any damage, injury, or malfunction resulting from following or misinterpreting this guide. All installation work must be performed exclusively by a licensed electrician in compliance with AS/NZS 3000 standards.